Instructions
It is very important that the shifter
be set properly to ensure correct engagement and disengagement and not create
undue stress on rear internals. Place the rear in gear and the shifter handle
in gear (down). Adjust cable until it freely goes on and off the quick
disconnect installed on the rear shifter arm. Once complete lift handle taking
the rear out of gear and remove cable from disconnect ensuring that the shifter
arm reached the end of its travel in disengagement. Reconnect cable and engage
the shifter handle. Check again to make sure the cable freely can release from
the quick disconnect and the shifter arm on the rear is fully locked in.
**SHIFTER CABLES ADJUSTED WITH EXCESSIVE TENSION HOLDING THE ARM IN GEAR WILL
CAUSE THE REAR TO JUMP OUT OF GEAR. WHEN PROPERLY INSTALLED THERE SHOULD NOT BE
ANY TENSION ON THE CABLE**







